Oki Pro8432WT User Manual

- 16 -
Checking the Placement Environment
1
1. Setup
●● Checking the Placement Environment
Placement Environment
Your printer must be placed in the following
environment:
Temperature: 10 - 32°C
Humidity:
20%
- 80% RH
(relative humidity)
Maximum
wet bulb
temperature:
25°C
Recommended
environment:
17 - 27°C, 50 - 70 % RH
Note
● Be careful of condensation. It may cause a malfunction.
● If placing your printer in a location where the humidity of
the surrounding air is less than 30% RH, use a humidier
or antistatic mat.
WARNING
● Do not install near high temperature or the re.
● Please do not install in a place from which a
chemical reaction is started (laboratory etc.).
● Do not install near the inammable solution, such
as alcohol and thinner.
● Do not install in the place which the small child's
hand reaches.
● Do not install in an unstable place (the shaky
stand, leaning place, etc.).
● Do not install in a place many humidity, dusty and
the place where direct rays hit.
● Do not install in the environment of briny air and
corrosive gas.
● Do not install in a place with much vibration.
● Do not install in a place where the ventilation hole
of the printer is closed.
CAUTION
● Do not place directly on a rug or carpet with long
strands.
● Do not install in a closed room with poor
ventilation and circulation.
● If you use the printer in a small room for a long
time, please make sure that you ventilate the
room.
● Install away from strong magnetic elds and
sources of noise.
● Install away from monitors or TVs.
Placement Space
Place your printer on a at surface that is wide
enough that the printer’s feet securely on the
surface.
Allow for enough room around your printer as
shown in the images below.
● Top view
20 cm
20 cm
100 cm60 cm
● Side view
70 cm

Oki Pro8432WT Specifications

General

Brand	Oki
Model	Pro8432WT
Category	Printer
Language	English