- 58 -
Setting the Time that Elapses Before Entering the Power Save Mode
2
2. Printing Basic Operation
●● Setting the Time that Elapses Before Entering the
Power Save Mode
Note
● When a printer is in the power saving mode, press the <POWER SAVE> button to restore from the mode.
● Check if the message “Ready To Print” appears. If the message is not displayed, press the <ON LINE> button.
1 Press the <Fn> key on the operator
panel.
2 Enter “200” using the numeric keypad
and then press the <ENTER> button.
3 Press the scroll button or to specify
the time and then press the <ENTER>
button.
4 Press the <ON LINE> button.
Memo
● The power save time can be selected from the followings:
- [1 minute]
- [2 minutes]
- [3 minutes]
- [4 minutes]
- [5 minutes]
- [10 minutes]
- [15 minutes]
- [30 minutes]
- [60 minutes]