- 106 -
Cleaning
4
4. Maintenance
●● Cleaning
This section explains how to clean each part of your printer.
Cleaning the Surface of the
Printer
Note
● Do not use benzine, thinners, or alcohol as a cleaning
agent. They may damage the plastic parts of the printer.
● Do not lubricate your printer with oil.
1 Turn off your printer by pressing the
power switch.
Reference
● “Turning Off the Power” P.22
2 Wipe the surface of the printer with a
soft cloth lightly moistened with water or
neutral detergent.
3 Dry the surface of the printer with a dry
soft cloth.
Cleaning Paper Feed Rollers
Clean the paper feed rollers if paper jams occur
frequently.
Note
● You should replace the paper feed rollers if paper jams
keep occurring even after cleaning the paper feed rollers.
For Tray 1
1
Pull out the tray (1).
1
2 Wipe the two paper feed rollers (2)
inside the printer with a wet cloth that
has been wrung out well.
2
3 Remove paper loaded in the tray.
4 Wipe the paper feed roller (3) on the
tray with a wet cloth that has been
wrung out well.
3
5 Load paper in the tray.
6 Push the tray back into the printer.
For MP Tray
1
Open the MP tray (1) forward by
inserting your ngers into the front
recesses (2).
2
2
1
To Next Page
Loading...
Need help?
General
