Driver Temperature Knob
Auto Button
The left (DRIVER) knob sets
the
temperature for
the
entire system when the right (PASS) knob is in the
center or neutral position. Turn the DRIVER knob
toward red
to
the right to raise the temperature. Turn it
toward blue to the left
to
lower the temperature. The
display will show your selection for a few seconds,
then
the outside temperature will show. If you push
the
knob
the set temperature will again be displayed for
a
few
seconds, then the outside temperature will show.
Passenger Temperature Knob
The right (PASS) knob
adjusts the air temperature
on the passenger's side
so
it is warmer or cooler than
the temperature set by
the driver.
Turn
the
PASS
knob toward red
to
the right
to
raise the
temperature. Turn it toward blue to the left to lower the
temperature. The passenger temperature will not be
shown in the display.
For the most efficient operation you should press the
AUTO button and set the system temperature.
The system will select the best fan speed and airflow
settings to keep you comfortable. The air conditioning
compressor will run if the outside temperature is
above 40°F (4.5"C). You may notice a delay
of
three to four minutes before the fan comes on.
Off
Button
Push
the
OFF button to turn the system off. The display
will show OFF and outside temperature. The system will
continue to automatically control air temperature to the
last set temperature.
Manual Control
If you prefer to manually control the heating, cooling
and ventilation
in
your vehicle, set the system to the
temperature and fan speed you want. Next, push the
desired airflow direction pushbutton. The system will
try to maintain the temperature you set using the mode
you select. The following suggestions will help the
system run more efficiently in manual mode.
3-5
To Next Page
Loading...
Need help?
General
