You can customize the vehicle to activate the Last Door
Closed Locking feature as described previously
or
to
completely disable the Last Door Closed Locking
feature at all times. If disabled, the doors will lock
immediately when a power door lock switch is pressed.
The Last Door Closed locking feature is enabled and
disabled when the doors are closed and the ignition key
is in
ON.
Press and hold the power door lock switch in the unlock
position. While holding the door unlock switch, cycle
the transaxle out of and back into PARK
(P).
After an
initial transaxle cycle, each additional cycle will toggle
the enable/disable state
of
the Last Door Closed Locking
feature. During this customization procedure, the chime
will sound, providing the driver feedback. A single
chime will be heard if the Last Door Closed Locking
feature
is
disabled and two chimes will be heard if the
Last
Door
Closed Locking feature is enabled. When the
door unlock switch is released, the vehicle will remain
in the most recent operating mode.
The Last Door Closed Locking feature will be enabled
when the vehicle is shipped from the factory.
Disconnecting the vehicle’s battery for up to a year will
not change the programmed mode of the Last Door
Closed Locking feature.
Keyless
Entry System
If your vehicle has this option, you can lock and unlock
your doors or unlock your trunk from about
3
feet
(1 m)
up to
30
feet
(9
m) away using the remote keyless entry
transmitter supplied with your vehicle.
Your keyless entry system operates on a radio frequency
subject to Federal Communications Commission (FCC)
Rules and with Industry Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1)
this device may not cause interference, and
(2)
this
device must accept any interference received, including
interference that may cause undesired operation of
the
device.
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use this equipment.
2-8
To Next Page
Loading...
Need help?
General
