Remote Alarm
When you press the alarm button on the remote keyless
entry transmitter, the headlamps will flash, the horn will
sound repeatedly and the interior lamps will illuminate.
This will allow you to attract attention if needed. The
alarm will continue until:
Mode
3:
Headlamp Flash only
Mode
4:
Horn Chirp and Headlamp Flash
The driver presses the alarm button on the remote
keyless entry transmitter a second time,
The ignition is turned
to
ON
or
An alarm of 110 seconds has elapsed.
Remote Activation Verification (RAV)
This
feature helps provide an audible and/or visible feedback
that a remote keyless entry lock or unlock command has been
received and executed. The vehicle must be
off
for the
Remote Activation Verification to work.
You
may select one of four operating modes for the reception
of a lock command.
You
may
also
select one of four
operating modes for the reception of an unlock command.
The selection and programming of the lock and unlock
modes are independent of each other. The following modes
are available for either lock or unlock verification:
Mode
1:
No
Verification
Mode
2:
Horn Chirp only
The operating mode
of
the Remote Activation
Verification Lock (RAV Lock) feature will be changed
when the driver performs the following sequence with
the doors closed and the ignition key is in
ON:
1.
Press and hold down the power door lock switch in
the lock position.
2.
While holding the door lock switch, press and
release the
RKE
transmitter lock switch. This button
press will initialize the customization mode. Upon
initiation of this mode, the chime will sound the
number of chimes corresponding to the current
RAV lock mode.
Each additional press of the Remote Keyless Entry
transmitter lock switch will cause the vehicle to
increment the RAV lock mode by one, starting from the
current RAV lock mode. If cycled beyond RAV lock
mode
4,
the vehicle shall enter RAV lock mode 1. When
the door lock switch is released, the vehicle will remain
in the most recent RAV lock mode.
2-10
To Next Page
Loading...
