AM-FM Stereo with Cassette Tape Player
and Automatic Tone Control
Playing
the
Radio
PWR-VOL:
Press this knob to turn
the
system on and
off.
To
increase volume, turn the knob to the right. Turn
it to the left to decrease volume.
RCL:
Press this button briefly
to
recall the station being
played or
to
display the clock.
To
change what is
normally shown on the display (station or time), press
the
RCL button until you see
the
display you want, then
hold
the RCL button
until
the display flashes. If you
press the button when the ignition
is
off, the clock will
show for a few seconds.
Finding a
Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using
it.
SEEK:
Press the up or down arrow
to
go
to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release it to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then go on
to
the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and
SCAN
will appear on the
display.
If
you press
SCAN
for more than
two
seconds,
the radio will change to P
SCAN
mode.
P
SCAN
will
appear on the display.
3-10
To Next Page
Loading...
Need help?
General
