Unlocking
the
Theft-Deterrent Feature After
a
Power
Loss
Enter your secret code as follows; pause
no
more than
15 seconds between steps:
1.
LOC
appears when the ignition is on.
2.
Press
MN
and
000
will appear
on
the display.
3.
Press MN again to make the last two digits agree
with your code.
4.
Press
HR
to
make the first one or two digits agree
5.
Press AM-FM after you have confirmed that the
with your code.
code matches the secret code you have written down.
The display will show
SEC,
indicating the radio is
now operable and secure.
If
you enter the wrong code eight times, INOP will
appear on the display. You will have to wait an hour
with the ignition on before you can try again. When you
try again,
you
will only have three chances
to
enter the
correct code before INOP appears.
If
you
lose or forget your code, contact your retailer.
Disabling the Theft-Deterrent Feature
Enter your secret code as follows; pause no more than
15
seconds between steps:
1.
2.
3.
4.
5.
6.
7.
Turn the ignition
to
ACCESSORY
or ON.
Turn the radio
off.
Press the
1
and
4
buttons together. Hold them down
until
SEC
shows on the display.
Press MN and
000
will appear on the display.
Press MN again to make the last two digits agree
with your code.
Press
HR
to make the first one or two digits agree
with your code.
Press
AM-FM
after you have confirmed that the
code matches the secret code you have written down.
The display will show
---,
indicating that the radio is
no longer secured.
If
the code entered is incorrect,
SEC
will appear on the
display. The radio will remain secured until the correct
code is entered.
When battery power is removed and later applied to a
secured radio, the radio won’t turn on and
LOC
will
appear on the display.
To unlock a secured radio, see “Unlocking the
Theft-Deterrent Feature After a Power
Loss”
earlier in
this section.
3-24
To Next Page
Loading...
Need help?
General
