EasyManua.ls Logo

Oldsmobile 1998 Intrigue - Part C: Periodic Maintenance Inspections

Oldsmobile 1998 Intrigue
340 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Part
C:
Periodic
Maintenance Inspections
Listed below are inspections and services which should be
performed at least twice a year (for instance, each spring
and fall).
You
should let
your
retailer’s service department
or
other qualiJied service center do these
jobs.
Make sure
any necessary repairs are completed at once.
Proper procedures to perform these services may be
found in a service manual. See “Service and Owner
Publications” in the Index.
Steering, Suspension and Front Drive Axle
Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose or missing parts, signs of
wear or lack of lubrication. Inspect the power steering
lines and hoses for proper hook-up, binding, leaks,
cracks, chafing, etc. Clean and then
axle boot seals for damage, tears or
seals if necessary.
Exhaust System Inspection
Inspect
the
complete exhaust system.
inspect the drive
leakage. Replace
Inspect the body near
the exhaust system. Look for broken, damaged, missing
or
out-of-position parts as well as open seams, holes, loose
connections or other conditions which could cause a heat
build-up in
the
floor pan or could let exhaust fumes into
the vehicle. See “Engine Exhaust” in the Index.
Engine Cooling System Inspection
Inspect the hoses and have them replaced if they are
cracked, swollen or deteriorated. Inspect all pipes, fittings
and clamps; replace as needed. Clean the outside
of
the
radiator and air conditioning condenser.
To
help ensure
proper operation, a pressure
test
of
the cooling system
and pressure cap
is
recommended at least once a year.
Throttle System Inspection
Inspect the throttle system for interference or binding,
and for damaged or missing parts. Replace parts as
needed. Replace any components that have high effort
or
excessive wear.
Do
not lubricate accelerator and
cruise control cables.
Brake System Inspection
Inspect the complete system. Inspect brake lines and
hoses for proper hook-up, binding, leaks, cracks,
chafing, etc. Inspect disc brake pads for wear and rotors
for surface condition. Inspect other brake parts,
including calipers, parking brake, etc. Check parking
brake adjustment. You may need to have your brakes
inspected more often if your driving habits
or
conditions
result in frequent braking.
7-17

Table of Contents

Related product manuals