To check the aim, the vehicle should be properly
prepared as follows:
For
the
vertical
adjustment,
state
inspection
stations
will
generdy
dhw
areading
of
plus
0.76 degrees
or
minus
0.76
degrees from
the
center
of
the
bubble.
0
0
Place the vehicle on a level pad or surface.
The vehicle should not have any snow, ice or mu(
attached to it.
0
0
0
0
0
1
The vehicle should be fully assembled and all other
work stopped while headlamp aiming is being done.
There should not be any cargo or loading of the
vehicle, except it should have a
full
tank
of
gas and
one person
or
160
lbs.
(75
kg) on the driver's seat.
Close
all
doors.
Tires should be properly inflated.
Rock the vehicle to stabilize the suspension.
NOTICE:
To
make sure your headlamps are aimed
properly, read all the instructions before
beginning. Failure to follow these instructions
could cause damage to headlamp parts.
Dl
.2"
.4"
It
is
recommended that the
upper limit not exceed
plus
0.4
degrees from the
center of the bubble.
Other drivers may flash
their high beams at you
if
your adjustment
is
much
above plus
0.4
degrees.
6-34
To Next Page
Loading...
Need help?
General
