2
Overview
2-6 d-Color MF201
2.3 Setting up the system
In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the fax driver onto the computer
being used.
Detail
This manual describes the setup method of network connection only for Port9100 that will be installed
by the installer, and LPR/Port9100 that will be installed by Add Printer Wizard printing.
For installation procedures via other network connections, refer to the User manual – Print Operations.
2.3.1 Network connection
1 Connect this machine to a computer.
2 Make sure the computer is connected to the network.
3 Specify the IP address of the machine to connect it to the network.
4 Depending on the connection method and protocol, change the network settings of this machine.
– LPR: Enable the LPD settings with the software switch (mode 384).
– Port9100: Enable the port setting with the software switch (mode 384), and specify the RAW port
number (default setting is "9100") in "Network Settings".
5 Install the fax driver.
– Specify the network port of the fax driver according to the connection method and protocol.
2.3.2 Local connection
1 Connect this machine to a computer
2 Install the fax driver.
Detail
For details on connecting this machine to a computer, refer to the User manual – Print Operations.
To update an existing fax driver, delete the existing fax driver first. For details, refer to "Uninstalling the
fax driver" on page 3-15.
To Next Page
Loading...
Need help?
General
