GETTING STARTED 7
3 If the top cover was removed, replace it after copying by sliding its tabs into the related slots on the rear
of the printer until they click into place. Close the top cover.
LOADING PAPER
1 Raise the two paper supports into their upright position, then squeeze and slide the paper width guide
to its outermost position.
note: When raising the paper supports make sure that they are in their correct upright position.
2 Load the paper vertically (portrait orientation), the side to print on facing the front of the printer and
against the guide on the right side of the paper support.
Squeeze and slide the left paper guide against the left edge of the paper.
To Next Page
Loading...
