CHAPTER 330
Entering WEP keys
To enter WEP keys in the Web Server mode proceed as follows:
1 Click on the Networking/Wireless tab.
2 Go to the Encryption section where you can add the Static coding parameters (WEP).
3 Select Activated.
4 Enter the WEP keys used by the network. Select whether the keys entered are Alphanumeric or
Hexadecimal. Select the key to be used for encryption of the data transmitted.
5 Click on Apply to save the keys in the printer.
note: If you have forgotten the WEP keys, display these via the access point. If the access point does
not display the keys, reconfigure the network and assign new keys.
Entering WPA Coding Data
The WPA (Wi-Fi Protected Access) function affords interoperable protection based on standards in
order to promote a considerable increase the level of data protection and access control for a wireless
LAN. To increase data encryption, WPA uses TKIP (Temporal Key Integrity Protocol). For stricter user
authentication, WPA implements EAP (Extensible Authentication Protocol).
If WPA is used on the network, PSK (Pre-Shared Key) authentication is used.
In the Web Server mode proceed as follows:
1 Click on the Networking tab.
2 In the network Settings page, select the Wireless tab.
3 Go to the Authentication section and click on Advanced configuration. The wireless communication
mode page is displayed.
4 Select Infrastructure and click on Next. A page with the name of the wireless network is displayed.
5 Select a network name (SSID) from the list of networks identified or enter the name of a new wireless
network. Click on Next. The Wireless authentication page is displayed.
6 Select EAP/PSK. Enter a password Phrase (with a length of between 8 and 63 characters including
spaces) that will be used by the software to generate a pre-shared key.
note: All network peripherals must use the same phrase as password.
7 Carry out the instructions displayed in order to configure the printer for the type of authentication and
coding selected. On completion, click on Next. The Configuration preview page is displayed.
8 Check that the information is correct, click on Apply to save the keys in the printer.
To Next Page
Loading...
Need help?
General
