Contents
i
1. Introduction 1
2. Safety precautions 2
2.1 Laser safety 2
2.2 CAUTION:Safety precautions 2
2.3 WARNING:Prevention of electric shock 2
2.4 CAUTION:Electric safety 3
2.5 CAUTION: LED (light emitting diode) 3
2.6 Safety symbols 3
2.7 Caution engraving/label 4
2.8 Specifications 4
2.9 Restrictions 5
3. Setup procedures 6
3.1 Removing the transport lock from the motorized light guide reflected light illuminator 6
3.2 Attaching the motorized light guide reflected light illuminator 6
3.3 Attaching the Autofocus Sensing Unit to the motorized light guide reflected light illuminator 7
3.4 Installing the control box 9
3.5 Setting up BXC-CBB 10
3.6 Setting up BXC-CBE1 12
3.7 Attaching the objectives 12
3.8 Attaching the nosepiece 12
3.9 Storing the motorized nosepiece connector of the motorized light guide reflected light
illuminator 13
3.10 Attaching the light source for reflected light illumination 14
3.10.1 Attaching the LED illumination 14
3.10.2 Attaching the liquid light guide or mercury lamp housing 15
3.10.3 Attaching the motorized reflected filter wheel U-FWR 15
3.10.4 Attaching two lamp housings 17
3.10.5 Attaching the light source for motorized light guide reflected light illuminator with clean lens for AS (BXC-RLI-
LGCA) 17
3.10.6 Attaching a third-party light source 18
3.11 Setting up BXC-FSU 18
3.11.1 Product outline of BXC-FSU 18
3.11.2 User-I/F 19
3.11.3 Adjusting camera diopter 21
3.11.4 Parfocalizing objective lenses 22
3.11.5 Correcting chromatic aberration of the lenses 22
3.12 Connecting cables 23
3.12.1 Connecting a cable to the motorized light guide reflected light illuminator 23
3.12.2 Connecting cables to BXC-CBB 23
3.12.3 Connecting cables to BXC-CBE1 26
4. Operation procedures 27
4.1 Status display of the indicators on BXC-CBB 27
4.2 Status display of the indicators on BXC-CBE1 27
4.3 Adjusting the aperture diaphragm (AS) 28
4.4 Using the interlocked ND filter for BXC-RLI 29