30
BASIC SHOOTING OPERATIONS
Shooting Pictures
Lens barrier
When starting shooting
When ending shooting
1. To start shooting:
Open the lens barrier until the flash
pops up.
[ The camera turns on, and the lens
comes out.
2. To end shooting:
Close the lens barrier.
[ The camera turns off. Press the flash
down with a finger.
To save battery power
Sleep mode:
When no operation is performed for 1
minute with the lens barrier open, the
camera enters the Sleep mode. This
mode reduces the consumption of
battery power, and automatically
switches off the monitor.
To resume shooting, do any one of the
following:
v Press the shutter button gently.
v Close the lens barrier and open it again.
v Press any of the arrow pad keys,
OK/menu button, monitor
button or zoom lever.
v Images stored on the card are saved even after the camera turns off or
the batteries are replaced.
v Try to minimize power consumption as much as possible if you don’t
expect to use the camera for a while. Turn the power off by closing the
lens barrier.
v When you close the lens barrier, slide it a little toward the lens. After the
lens goes in, close the lens barrier.
To Next Page
Loading...
Need help?
General
