97
TROUBLESHOOTING
If Image Quality Is Poor
Cause Remedy See
When the image is too bright
The Flash mode is set to the Fill-in
Flash mode.
Close the lens barrier to restore the Auto-Flash
mode, or select the Flash Off mode.
P. 57
The subject was too brightly
illuminated.
Correct the exposure (in [–] direction) or shoot the
subject from a different angle or point the camera
in a different direction and lock the exposure.
P. 65
Cause Remedy See
See
When the image is too dark
You blocked the flash with your
finger, etc.
Hold the camera correctly, taking care not to
cover the flash surface.
P. 28
The subject was out of reach of the
flash.
Shoot the subject from a distance of less than
about 3.5 m/11.5 ft.
P. 56
You shot a dark subject against back
light.
Set the Flash mode to the Fill-In Flash mode. P. 57
Cause Remedy
When the colors in an image shot indoors are abnormal
The image color tone is affected by
the illumination light.
Set the Flash mode to the Fill-In Flash mode. P. 57
The white balance control setting is
wrong.
Set the white balance control according to the
lighting condition.
P. 67
The subject does not contain any
white.
Shoot the subject with something white in the
field of view or set the white balance control
according to the current lighting condition.
P. 67
To Next Page
Loading...
