Olympus CAMEDIA C-1 Zoom - Erasing All Pictures (All-Frame Erase)

47
VIEWING OR ERASING IMMEDIATELY AFTER SHOOTING
Erasing All Pictures (All-Frame Erase)
Check that the lens barrier is closed and the
camera is set to the Playback mode by
holding down the monitor button for a moment.
The following operation clears the card of all stored image data.
Operating Procedure
1. Press the OK/menu button.
2. Press the or arrow pad key
to select
/
.
[ The display changes to “YES”.
3. Press the OK/menu button.
[The card setup screen is displayed.
4. Select by pressing the or
arrow pad key.
5. Select “YES” by pressing the or
arrow pad key.
6. Press the OK/menu button.
[ All of the image frame data saved in the
card will be erased.
To cancel all-frame erasure:
In step 5, select “NO” and press the
OK/menu button.
Erasure time may be prolonged if
the card has been subjected to
print reservation ( Page 76).
This is not a malfunction.
v Erasure is not possible if the
image to be erased is protected or
a write protect seal is attached to
the card ( Pages 50, 51).
v For details on handling your card,
refer to the instructions provided
with it.
1/3
SET
OK
SELECT
NO
OFF
YES
NO
NO
NO
SET
OK
SELECT
Check the following before
erasing images
To prevent destruction of data on the card, never attempt to open the card cover, remove
the batteries, disconnect the AC adapter or remove the card during erasure.
YES
NO
Playback mode menu 1/3 screen
Card setup screen