Olympus CH Series - Page 16

CUK2_6x5SA
AA800200
Fig. 3·18
AA784700
3-5-4 Aher removing three Screws CUK2.6x5SA
and three Washers AA800200, pull out leh
Coarse adjustment knob AA784700.
(See Fig. 3-18)
Fig. 3-19
3-5-5 Disassemble Shaft holder AA872200 in the
following procedures:
a) Loosen two Screws ACU3x6SA.
(See Fig. 3-19)
Fig. 3-20
•
b) While holding the right coarse adjustment
knob by hand, turn the shaft holder a little
counterclockwise with pliers. After the shaft
holder
is loosened a little, turn the coarse
adjustment
knob clockwise. (See Fig. 3-20)
NOTE:
The pre-focusing lever should be unlocked in
advance.
-12-