Olympus CH Series - Disassembling Procedures for C-CH Condenser Holder; Dismount Left Dovetail

b) By using a screwdriver or tweezers, adjust the
casing
to the center of the inner guide unit.
(See Fig. 4-41)
Fig.441
c) By using Torque screwdriver OT0044, tighten
two Setscrews GUK2.6x10SA for the fixing
piece. (See Fig. 4-42)
Tightening torque:
800 g-cm
d)
Apply Shellac OT1131 to the screws to
prevent loosening.
e)
Finally fix inner guide AA819700 by tighten-
ing three Screws AB3x10SA.
Fig. 442
5. DISASSEMBLING PROCEDURES FOR C-GH CONDENSER HOLDER
5-1 By removing two Screws GUK3x10SA, dis-
mount left Dovetail AA870800. (See Fig. 5-1)
Fig. 5-1
-31-