8.1 Troubleshooting
103
CLV-190 INSTRUCTION MANUAL
Ch.8
Chapter 8 Troubleshooting
If any irregularity is observed during inspecting as described in Chapter 4, “Inspection” and Chapter 3,
“Installation and Connection” or using as described in Chapter 5, “Operation”, do not use the light
source and solve the problem as described in Section 8.2, “Troubleshooting guide”. If the problem
cannot be resolved, contact Olympus.
Never use the light source if an irregularity is observed. Damage or irregularity of
the light source may result equipment damage, an electric shock, and/or burns.
The following table shows the possible causes of and countermeasures against troubles that may
occur due to errors of settings or deterioration of consumables.
When troubles or failures other than those listed in the following table are observed, turn OFF the light
source once and turn it ON again. If the problem still cannot be resolved, return the light source for
repair as described in Section 8.3, “Returning the light source for repair”.
8.1 Troubleshooting
8.2 Troubleshooting guide
To Next Page
Loading...
