Olympus CLV-190 - 5.2 Operation Workflow

68
5.2 Operation workflow
CLV-190 INSTRUCTION MANUAL
Ch.5
Please see the operation workflow below. Follow each step of the workflow for using the light source.
5.2 Operation workflow
1
Inspect the light source and the ancillary equipment.
Chapter 4 on page 41
2
Turn the light source ON and ignite the examination lamp.
Section 5.3 on page 69
3
Set the brightness mode.
Section 5.4 on page 70
4
Adjust the brightness of the examination lamp.
Section 5.5 on page 71
5
Operate the light source.
• Optical-digital observationSection5.6 on page74
• TransilluminationSection 5.7 on page 76
• High intensity modeSection 5.8 on page 77
• Air and water feedingSection 5.9 on page 78
6
After examination, extinguish the examination lamp or turn the
light source OFF.
• Extinguish the examination lampSection 5.10 on page 79
• Turn the light source OFFSection 5.11 on page 80
7
Disconnect the endoscope.
8
Care for and store the light source and accessory as appropriate
after use.
Section 7.1 on page 93