28
3.2 Installation workflow
CLV-190 INSTRUCTION MANUAL
Ch.3
Please see the installation workflow below. Follow each step of the workflow before using the light
source and the ancillary equipment.
3.2 Installation workflow
1
Install the light source and the ancillary equipment on the mobile
workstation or another stable location.
Section 3.3 on page 29
2
Install the water container.
Only if air/water feeding function is used.
Section 3.4 on page 33
3
Select the lamp ignition mode.
Section 3.5 on page 33
4
Connect the light source to the video system center.
(Only if the video system center is used.)
Section 3.6 on page 35
5
Connect the foot switch.
(Only if the footswitch is used.)
Section 3.7 on page 38
6
Connect the light source to the power supply.
Section 3.8 on page 39
To Next Page
Loading...
