40
3.8 Connection to the AC mains power supply
CLV-190 INSTRUCTION MANUAL
Ch.3
The plug of the power cord that follows the equipment may vary from this drawing,
as in each country the commercialized cable is in accordance to the local
applicable norm.
1 Confirm that the power switch is not pressed in.
2 Connect the power cord to the AC power inlet
of the light source and to the mobile
workstation (WM-NP2, WM-DP2, WM-NP1, or
WM-WP1) or the wall mains outlet.
Figure 3.12
To Next Page
Loading...
