Instrument Nomenclature and Functions
1
1.3 Rear Panel
13
1.3 Rear Panel
A Power inlet
Connect the power cord for AC power supply.
B Equipotential terminal
For safety, connect this terminal to the equipotential
bus bar of the hospital.
C REMOTE 1 terminal
When using the optional remote control unit (MAJ-
898) for wired remote control of this instrument,
connect the remote control unit here.
D REMOTE 2 terminal
When communication with the video system center
is required, connect the OEP cable (MH-987) or
remote cable (MH-907) here.
E SDI video input terminal
Input the SDI video signals from connected
equipment, such as a video system center or monitor.
Either SDTV or HDTV signals can be input.
F SDI video output terminal
Output the SDI video signals to connected
equipment, such as a video system center or
monitor.
Either SDTV or HDTV signals can be output.
G RS-232C terminal
When communication with the video system center
is required, connect the remote cable (MH-995 or
MH-877) here.
H REMOTE 3 terminal
This terminal is for future expansion. Not used.
I OUTPUT (RGB video output) terminals
Output the RGB video signals to connected
equipment, such as a monitor.
Either SDTV or HDTV signals can be output.
J INPUT (RGB video input) terminals
Input the RGB video signals from connected
equipment, such as a video system center or
monitor.
Either SDTV or HDTV signals can be input.
K S VIDEO OUT (output) terminal
Outputs S-Video signal to connected equipment,
such as a monitor.
L S VIDEO IN (input) terminal
Inputs the S-Video signal from connected
equipment, such as a video system center or
monitor.
M VIDEO OUT (Composite video output) terminal
Outputs the composite video signal to connected
equipment, such as a monitor.
N VIDEO IN (Composite video input) terminal
Inputs the composite video signal from connected
equipment, such as a video system center or
monitor.
To Next Page
Loading...
