System Setup
5
5.1 Items That can be Set on Menus
47
PRINTER
SETUP -
FUNCTION
SETUP
AUTO LIVE “OFF” “ON” Switch the output image at capturing between
the memory and source image.
“OFF”
RM2 FUNC (See Table 5.3. on
page 57)
Set the function of the “REMOTE2” terminal. “C&PRINT”
CLEAR “ALL” “PAGE”
“PART” “OFF”
Set the operation activated with the CLEAR
button on the front panel.
“ALL”
STORE MODE “OEP-4 MODE”
“OEP-5 MODE”
“OFF”
Set a mode in which image and setting data is
saved or loaded when a paper jam occurs.
“OEP-4 MODE”
STORE IMAGE “STORE”
“RESTORE”
“CLEAR”
Store, load or clear image and setting data
using the built-in memory.
“RESTORE”
PRINTER
SETUP -
COLOR
BALANCE
BAL X “1” to “99” Set the reference range for color tone
adjustment in printed picture.
“50”
BAL Y “1” to “99” Set the reference range for color tone
adjustment in printed picture.
LOAD USER 1, 3: “50”
LOAD USER 2: “30”
BAL STEP “1” to “20” Set the adjustment steps for color tone
adjustment in printed picture.
“5”
TEST PRINT Start test print.
SIGNAL
SETUP -
INPUT
SETUP
INPUT SEL “VIDEO” “S-VIDEO”
“COMPONENT”
“SDI”
Set the input video signal format. “SDI”
SD/HD SEL “SD” “HD” “AUTO” Set whether the HDTV or SDTV signal is
input.
“AUTO”
SD FORMAT “RGB” “YCbCr” Set the input SDTV signal format. “RGB”
SD SYNC (IN) “G-ON” “EXT” Set the input SDTV signal sync format. “EXT”
HUE “-14” to “14” Adjust the hue when the composite video or
S-video signal is input.
“0”
COLOR “OFF”
“-13” to “14”
Adjust the color depth. “0”
GAIN “-14” to “14” Adjust the contrast. “0”
OFFSET “-14” to “14” Adjust the brightness. “-2”
SIGNAL
SETUP -
OUTPUT
SETUP
DISPLAY “OFF” “ON” Set whether the setups are displayed.
Same as the DISPLAY button on the front
panel.
“ON”
RBN REMAIN “OFF” “ON” Set whether the remaining ink ribbon
information is displayed.
“ON”
SOURCE “THRU” “EE” Set whether the color tones in the output
image to a monitor are adjusted.
“EE”
SD OUTPUT
SYNC
“EXT” “EXT & G-ON” Set the SDTV video signal sync format that
outputs an image to a monitor.
“EXT”
Ta bl e 5. 1
Menu Item Setting values Details Factory default
To Next Page
Loading...
