Olympus USPM-RUIII Series - Page 103

13. About the Alarm and Error Indications
PV6253-F4E016 61
 “Configuration file version error”
An attempt was made to load an configuration file (*.env.) in different version. Check the
version. The configuration parameters will be set to the system default values.
 “An error occurred while creating the configuration file”
Write of the configuration file (*.env) failed. The parameters will not be saved. Use the
property to check to see if the specified configuration file is inhibited from being written.
 “An error occurred while loading the wavelength calibration file”
Loading of the wavelength calibration file (uspm.cal) failed. The calibration value will be set
to Default value 4. Execute calibration again in the wavelength direction. When calibration is
conducted, the file will be automatically saved.
 “An error occurred while creating the wavelength calibration file”
Write of the wavelength calibration file failed. Check to see if the calibration file (uspm.cal) is
inhibited from being written. The calibration value will not be saved.
 “An error occurred while loading the standard file”
Loading of the standard file (*.std) failed. Check to see if the specified directory contains the
specified standard file. No standards will be set up.
 “An error occurred while creating the standard file”
Check to see if the specified standard file (*.std) is inhibited from being written.
 “An error occurred while loading the reference file”
Loading of the reference file (*.ref) failed. Set the reference data again through the
[System][Reference Setup] menu.
 “An error occurred while creating the reference file”
Check to see if the reference data (*.ref) is inhibited from being written, and if the specified
directory exists.
 “An error occurred while loading the refraction index file”
Loading of the refractive index file (*.ind) to be used in film thickness measured failed. Check
to see if the specified refractive index file is contained in the specified directory. Set again the
refractive index of the coating material.
 “An error occurred while creating the refraction index file”
Write of the refractive index file (*.ind) failed. Check to see if the specified refractive index
file is inhibited from being written.