12. File Configuration
PV6253-F4E016 51
12. File Configuration
USPM-RU uses the following files on the program.
12.1. Startup file (uspm.int)
This file is loaded at the time USPM-RU is launched, and is named "uspm.int". This file stores
the name of the configuration file which was in use when USPM was last closed. When the
stored configuration file is loaded again, the program can be started up in the same environment.
If the loading of the startup file fails, an error message will be displayed, and the measurement
setup parameters will take the default values (set in the system program).
Data file ID tag
Configuration file name (*.env) (*: An arbitrary file name)
Port No.
Wavelength calibration value 1
Wavelength calibration value 2
Wavelength calibration value 3
Wavelength calibration value 4
Wavelength calibration value 5
Wavelength calibration value 6 (440nm - 840nm excluded)
Waiting time of shutter
[end]
12.2. Calibration file (uspm.cal)
This data file stores the indication calibration values in the wavelength direction of USPM. The
file is always loaded at the time the program is launched, and the spectral reflectance is
indicated in accordance with that data. If an error occurs during the file load, Default Value 4
will be set.
12.3. Configuration File (*.env)
This file stores the measurement setup parameters of USPM-RU, its extension being "*.env".
When configuration files are individually created for different samples, it is possible to set up
measurement environments by loading the files. The file-related data includes the following:
Name of coating material spectral dispersion data file (*.ind)
Spectral dispersion data file of the reference (*.ref)
To Next Page
Loading...
