Olympus USPM-RUIII Series - Replacement of Fuses

PV6088-F4E017
29
7. REPLACEMENT OF FUSES
The fuse is located in a tray at the lower part of the power cord connector on the light
source and control box power supplies. Determine which power supply’s fuse needs to
be replaced.
Rating of fuses: 250 V AC, 3.15 A
Type of fuses: Time lag , High breaking capacity type
Size of fuses: φ5.2 mm  20 mm
Example: FIH,250V,3.15A （Made by Nippon Seisen Co.,Ltd.）
* Compatible parts available
(1) Replacement of the fuse in the light source power supply
(2) Replacement of the fuse in the control box
1) Pull out the fuse tray located at the lower part
of the power cord connector with a flat
screwdriver on the notch.
The fuse is located in a tray at the lower part
of the power cord connector. The method is
similar to that for the light source box.
2) Draw the tray out, pick out the fuse on the
tray, insert a new fuse, and push the tray back in
with your finger.
Always turn off the power and unplug the power cord before
removing or installing or a fuse.