PV9386-F4E005
14
(5) Confirm restarting the computer is completed, then connect GRIP USB Connecting
Cable into USB Connector.
(6) Next, perform the initial settings by editing the settings file contents. Double-click to
open the “USPM.int” file located in the folder into which the USPM-RU/RUIII software
has been installed (C:¥USPM¥ or ¥USPM440 by default). If it cannot be opened,
right-click on the “USPM.int” file, select “Open with”, and select Notepad to open it.
(7) Check the numerical value that appears on the third line of the “USPM.int” file. This
number represents the serial port number, for which the default value is 5. Type 0 for
the setting. After the setting is complete, save and close the file.
To Next Page
Loading...
