Olympus USPM-RUIII Series - Page 24

PV6088-F4E017
24
8) Connect the main unit cable to the main unit and the control box.
Connect the main unit cable in the orientation shown in Fig. 6.
9) Connect the USB cable to the computer and the control box.
10) Install the lamp into the lamp house.
For how to install a lamp, refer to 8. REPLACEMENT OF LAMP.
11) Connect the control box to the power supply.
12) Connect the power supply to the light source power supply.
13) Connect the computer to the power supply.
.
Figure 6. Orientation of the main unit cable