5. Details of [File] Menu
PV6253-F4E016 18
This format is equal to previous version
software like 1.10 or 2.00. All measured data
point is saved. Additional data is not created
This format is equal to previous version software
like 1.10 or 2.00 .Only 5 measured data points are
saved. An additional data is not created.
If saved reflectance data is to be loaded as a board refractive index file, save the data as "Data1".
5.3. [Open config file] menu
Opens an configuration file and loads it to the computer. The configuration file is one that
stores the measurement setup parameters of USPM-RU. When an configuration file with
optimum settings is created for each sample under measurement in advance, the measurement
settings will be able to be reproduced by simply loading that file.
The measurement setup parameters currently specified can be verified in the [Setting list]
window, which is opened through [Display] and [Setting list] Menu. The current
configuration file name is indicated in the status bar of the Main Window.
5.4. [Replace config file] menu
Saves measurement setup parameters under the current configuration file name by overwriting
the currently specified parameters.
5.5. [Save as] menu
Saves an configuration file by assigning an arbitrary name to it. When a file is named and saved,
the configuration file name currently in use is rewritten with this new file name.
5.6. [Print Setup] menu
Used to open the [Print] window and set up a printer.
Although configuration file of previous version like 1.10 or 2.00 can be
opened, standard file and formula2 data of reference and film thickness setting
can’t be opened. So that parameter is set to default.
To Next Page
Loading...
