3
Playback
45
EN
Playback
TIP
• You can change the playback
speed (
g
P. 42), and fast-
forward/rewind (
g
P. 38) when
the [
] indicator is blinking.
• If playback reaches the end of
the file when the [
] indicator
is blinking, the end of the file
is treated as the segment end
position, and repeat playback
starts.
3
Press the
REC
( K) button again
when playback reaches the
desired end position for ABC
repeat playback.
• Segment A-B is set, and ABC repeat
playback starts.
• When the [Shadowing] setting is
enabled, the repeated section is
played silently (low volume or slowly
depending on the setting) ([
]
lights up) after the repeated section
is played normally ([
] lights up).
This sequence of actions is
repeated until the setting is disabled.
Specifying new starting/ending
points:
g
Go to Step
4
Stopping ABC repeat playback:
g
Go to Step
6
Specifying new starting/ending
points
4
Press the
REC
( K) button
during ABC repeat playback.
• Segment A-B is canceled. [
#
]
becomes the new start position, and
playback continues.
• You can change the playback speed
(
g
P. 42), and fast-forward/rewind
(
g
P. 38).
• Shadowing playback does not work
until the end position is fixed.
5
Press the
REC
( K) button at the
desired end position for ABC
repeat playback.
• Segment B-C is set, and ABC
repeat playback starts.
• Shadowing playback works.
TIP
• Repeat Steps
4
and
5
to update
the ABC repeat segment.
To Next Page
Loading...
Need help?
General
