CMC 353 Reference Manual
8
SAFETY INSTRUCTIONS
Before operating the CMC 353 test set, carefully read the following
safety instructions.
Only operate (or even turn on) the CMC 353 after you have read this
reference manual and fully understood the instructions herein.
The CMC 353 may only be operated by trained personnel. Any
maloperation can result in damage to property or persons.
Rules for Use
•The CMC 353 should only be used when in a technically sound
condition. Its use should be in accordance with the safety regulations for
the specific job site and application. Always be aware of the dangers of
the high voltages and currents associated with this equipment. Pay
attention to the information provided in the reference manual and the
software documentation.
•The CMC 353 is exclusively intended for the application areas specified
in section 1, "Designated Use" on page 11. The manufacturer/
distributors are not liable for damage resulting from unintended usage.
The user alone assumes all responsibility and risk.
• The instructions provided in this reference manual and the associated
software manuals are considered part of the rules governing proper
usage.
• Do not open the CMC 353 or remove any of its housing components.
Orderly Practices and Procedures
• The reference manual (or its PDF version) should always be available on
site where the CMC 353 is used.
Note: The OMICRON Test Universe software installs a PDF version of
this reference manual. To view the manual, start the Test Universe Help
from the Start Page or any test module and navigate to the table of
contents entry User Manuals (at the beginning of the table of contents).
Click Hardware Manuals. In this topic you find a direct link to
"CMC 353". To open the manual, click the link.
• Personnel assigned to using the CMC 353 must have read this reference
manual and fully understood the instructions herein.
• Do not carry out any modifications, extensions or adaptations at the
CMC 353.
To Next Page
Loading...
Need help?
General
