OMICRON 23
Recording and saving data
7.3 Saving data
► After opening a dataset, start recording step and touch voltages.
► Start a measurement point by pressing .
Pressing again will complete the measurement. This will prompt the Save Data window:
For each new measurement point, the measurement ID is automatically increased by 1.
► If you skip a measurement point or would like to use one ID several times, edit the ID by marking
EDIT and pressing .
Note: If you use a measurement ID more than once, new results will not overwrite old results with the
same ID (see Figure 7-2: "HGT1 measurement report" on page 24).
Alternatively, datasets can be opened after a measurement has been completed. In this case, the
icon indicates unsaved data:
► Mark the icon using the scroll wheel, press and save the measurement by starting a new dataset
or opening an existing one (see 7.1 "Start new dataset" on page 22 and 7.2 "Continue existing
dataset" on page 22).
7.3.1 Close dataset
► Close a dataset by clicking the Save icon and selecting Close Dataset:
You can still save measurement points in any dataset by clicking the Save icon and selecting Continue
existing Dataset (see Figure 7-1: "Save menu" on page 22).
NOTICE
Loss of data
► Save every measurement point. Otherwise it will be overwritten by the next measurement you
perform.
Edit
measurement ID
Rename location ID
Measurement ID
To Next Page
Loading...
Need help?
General
