OMICRON 9
Safety instructions
1.4 Orderly measures
The MPD 800 User Manual or alternatively the e-book has always to be available on the site where the
MPD 800 acquisition unit is operated.
The users of the MPD 800 acquisition unit and its accessories must read this manual before operating
the MPD 800 acquisition unit and its accessories and observe the safety, installation, and operation
instructions therein.
The MPD 800 acquisition unit and its accessories may only be used in accordance with the user
documentation (including but not limited to User Manuals, Reference Manuals, Getting Started manuals
and manufacturer manuals). The manufacturer and the distributor are not liable for damage resulting
from improper usage.
Opening the MPD 800 acquisition unit or its accessories without authorization invalidates all warranty
claims. Any kind of maintenance, calibration or repair on the device itself may only be carried out by
persons authorized by OMICRON.
1.5 Disclaimer
If the equipment is used in a manner not described in the user documentation, the protection provided
by the equipment may be impaired.
1.6 Compliance statement
Declaration of conformity (EU)
The equipment adheres to the guidelines of the council of the European Community for meeting the
requirements of the member states regarding the electromagnetic compatibility (EMC) directive, the low
voltage directive (LVD) and the RoHS directive.
FCC compliance (USA)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Declaration of compliance (Canada)
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
To Next Page
Loading...
Need help?
General
