What you have received:
What you need:
Note:
Top bar x 1
Top bar removable part x 1
Wax foundation x 1
Sides x2
(Long ones for Brood
short ones for Supers)
Bottom bars x2
• Tack hammer
• Tack nails x 200
Its better to store wax
foundation flat in a plastic bag
in a cool place. Only assemble
frames when you need them.
Step 1: Remove part of the top bar
Remove the loose bar by levering away, it will snap cleanly off.
Keep to one side, it’s used at the end to secure the wax.
Push the side bars into place, making sure that the groove is
facing inwards.
Step 2: Attach sides to top bar
Tack a nail into each end of a bottom bar. Place this bar in the
slots in the side bars.
Gently hammer the nail all the way so that it attaches the
bottom bar to the side bars.
Step 3: Preparing wax foundation
Lay a sheet of wax foundation on the table. You’ll notice one
end has three wire tabs. Bend these up at 90 degrees.
Starting from the bottom with the bent wires at the top, slide
the sheet of wax foundation until it’s all the way in.
Guide to Assembling Your Frames
To Next Page
Loading...