MX2 Quick Start Guide
14 MX2 Quick Start Guide
3 PROGRAMMING MX2
3.1 Digital operator
The display is used in programming the inverter's parameters, as well as monitoring specific parameter values during operation
Items Contents
(1) POWER LED Turns ON (Green) while the inverter is powered up.
(2) ALARM LED Turns ON (Red) when the inverter trips.
(3) Program LED Turns ON (Green) when the display shows changeable parameter.
Blinks when there is a mismatch in setting.
(4) RUN LED Turns ON (Green) when the inverter is driving the motor.
(5) Monitor LED [Hz] Turns ON (Green) when the displayed data is frequency related.
(6) Monitor LED [A] Turns ON (Green) when the displayed data is current related.
(7) Run command LED Turns ON (Green) when a Run command is set to the operator. (Run key is effective.)
(8) 7-seg LED Shows each parameter, monitors etc.
(9) Run key Makes inverter run.
(10) Stop/reset key Makes inverter decelerates to a stop.
Reset the inverter when it is in trip situation
(11) CYCLE key Go to the top of next function group, when a function mode is shown
Cancel the setting and return to the function code, when a data is shown
Moves the cursor to a digit left, when it is in digit-to-digit setting mode
Pressing for 1 second leads to display data of , regardless of current display.
(12) Up key
(13) Down key
Increase or decrease the data.
Pressing the both keys at the same time gives you the digit-to-digit edit.
(14) SET key Go to the data display mode when a function code is shown
Stores the data and go back to show the function code, when data is shown.
Moves the cursor to a digit right, when it is in digit-to-digit display mode
(15) USB connector Connect USB connector (mini-B) for using PC communication
(16) RJ45 connector Connect RJ45 jack for remote operator
(4) RUN LED
(14) Set Key
(13) Down key(12) Up key
(11) CYCLE key
(9) RUN key
(7) Run command LED
(8) 7-seg LED
(6) Monitor LED [A]
(5) Monitor LED [Hz]
(1) POWER LED
(2) ALARM LED
(3) Program LED
(15) USB connector
(10) Stop/reset key
(16) RJ45 connector
I129E-EN-02+MX2+QuickStartGuide.book Seite 14 Mittwoch, 7. November 2012 1:54 13
To Next Page
Loading...
