Transport the product paying attention to the weight and balance, and
place and use it in a stable sturdy location.
Perform the installation operation in a stable flat place.
Operations should be carried out by two or more people.
Do not transport the product mounted on the 19 inch racks or the like.
⚫ The center of gravity of this product is off-center. Be careful not to drop it while
taking it out or transporting it.
⚫ As the product is heavy, it should be carried by 2 or more people.
⚫ You may be injured if the product is toppled or dropped.
⚫ The support angles or other parts may be bent and become unusable.
⚫ The mass of the unit is about 57 kg for the BU5002R, 31 kg for the BU3002R, and
about 30 kg for the BU3002RH.
⚫ Be careful not to catch your finger between the installation surface and the bottom
surface of the unit.
⚫ When moving, first remove the battery.
⚫ If the unit is dropped, stop using it immediately, and have it inspected and repaired.
For repairs, contact the shop of purchase.
Do not lift by holding the front panel.
⚫ There is a possibility that the panel comes off, leading to drop of a battery pack and
personal injury.
Be sure to connect the AC input of the unit to the commercial power
supply with the rated input voltage (200/208/220/230/240 VAC) and
frequency 50/60 Hz.
⚫ If connected to a commercial power supply with a different voltage or frequency, it
could cause a fire.
⚫ There is a risk of a breakdown of the unit.
If there is a fault (unusual noise or smell), disconnect the AC input from
the unit.
BU5002R: Either disconnect the AC input plug from the power outlet, or turn off
the input overcurrent protection switch “INPUT PROTECTION” on
the rear. Arrange the AC input plug in a nearby position where it can
be easily pulled out.
BU3002R: Unplug the AC input plug from the power outlet.
BU3002RH: Turn off the externally installed breaker installed on the input side.
⚫ For your safety, carry out the above operations during maintenance of the
connected devices, etc.
To Next Page
Loading...
