EasyManua.ls Logo

Omron BU5002R - Page 9

Omron BU5002R
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety precautions
BU5002R/BU3002R/BU3002RH
9
Warning (for installation and connection)
Do not connect to half-wave rectified devices whose current flows only
for half the cycle of the AC power supply, such as a blow dryer, some
solenoid valves, etc.
There is a risk of breakdown of the unit, smoke generation, or ignition.
When replacing an input/output cable of a terminal block model, fix the
cable with a terminal block cover.
If the cable connection is loosened, there is a risk of breakdown of the unit, smoke
generation, or ignition.
There is a risk of an electric shock.
Do not place the unit on other devices as it is heavy.
Do not place an expansion battery unit on the unit, or place the unit on an
expansion battery unit.
There is a risk that an injury could be caused if it falls.
Do not connect any standalone inductive device such as a coil
(transformer, electromagnet) or motor.
There is a risk of breakdown of the unit, smoke generation, or ignition.
Do not block the ventilation inlet and outlet (front and rear surfaces).
If the internal temperature increases, there is a risk of breakdown of the unit,
battery degradation, smoke generation, or ignition.
Install so that the distance from a wall to the front surface is 5 cm or more, and 10
cm or more to the rear surface.
When using support angles, be sure to use the ones provided with this
product.
If support angles other than the accessory items are used, there is a possibility that
support angles break apart and the unit falls down, which may lead to an injury.
When installing onto a rack, be sure to use the provided support angles
to support and fix this product.
Support each unit individually with support angles.
When installing onto a rack, be sure to use both the support angles and ear
brackets provided with this product. The ear brackets alone cannot support this
product without the support angles.
The mass of each unit is about 57 kg for the BU5002R, about 31 kg for the
BU3002R, and about 30 kg for the BU3002RH.
There is a risk that an injury could be caused if the unit falls.

Table of Contents

Related product manuals