Omron E5AN-H

239
Initial Setting Level Section 5-9
• Default: Event Input Assignment 1: none
Event Input Assignment 2: stop
(For Controllers supporting
event inputs 3 and 4, the default
is none.)
Event Input Assignment 3: none
Event Input Assignment 4: none
Note (1) PRST (Program Start) can be set even when the Program Pattern param-
eter is set to OFF, but the function will be disabled.
(2) This can be selected only for models that support the remote SP function.
(3) This setting will be ignored for heating/cooling control or for position-pro-
portional (floating) control.
(4) This can be selected only for models that support communications. Also,
when a work bit is selected as event input data, communications writing
enable/disable cannot be selected.
■ Related Parameter
Bank Numbers Used (initial setting level): Page 237
• This parameter is used to select the control method for position-propor-
tional control.
Setting Function
none None
stop RUN/STOP
manu Auto/Manual
prst Program start (See note 1.)
drs Invert Direct/Reverse Opera-
tion
rsp SP Mode Switch (See note 2.)
at-2 100% AT Execute/Cancel
at-1 40% AT Execute/Cancel (See
note 3.)
wtpt Setting Change Enable/Dis-
able (See note 4.)
cmwt Communications Write
Enable/Disable
lat Alarm Latch Cancel
Setting
See
See
clfl Closed/Floating
Position-proportional control must be
supported and there must be a
potentiometer input.
Setting range Default
flot: Floating
clos: Closed
flot
Function
Setting