334
Appendix
(11) Initialized to 4.0 for close control and to 2.0 for floating control.
(12) If the ST is changed to ON, the SP Mode will be initialized to LSP and the remote SP function will
be disabled.
(13) If the remote SP function is disabled, the SP Mode will be initialized to LSP.
(14) The default values are as follows:
Temperature Input
Depends on the setting of the PID Set Automatic Selection Data parameter and the upper and lower
limits for the input setting range (which depends on the temperature unit).
• PID Set Automatic Selection Data = PV: Upper limit + 20°C (40°F)
• PID Set Automatic Selection Data = DV: Upper limit − Lower Limit + 20°C (40°F)
• PID Set Automatic Selection Data = SP: Upper limit
Analog Input
The default is 105.0 (regardless of the setting of the PID Set Automatic Selection Data parameter.
(15) Initialized when the input type is changed from a temperature input to an analog input or from an
analog input to a temperature input.
(16) The proportional band, integral time, and derivative time are initialized when the input type is
changed from a temperature input to an analog input or from an analog input to a temperature input.
(17) Initialized to 233 if the integral time is 0 and the Close/Floating parameter is set for floating control.
(18) Event input assignments used for bank selection are initialized to NONE. They are also initialized to
NONE when only event inputs 3 and 4 are supported (i.e., when only two event inputs are support-
ed).
(19) If the ST is enabled, the SP Mode is initialized to LSP and the remote SP function is disabled.
(20) Initialized to 0.8 when the temperature unit is °C, and to 1.4 when the temperature unit is °F.
(21) When the program valid bank is exceeded and the Program Pattern parameter is not OFF.
(22) Initialized to Stop if the Program Pattern parameter is not OFF.
To Next Page
Loading...
Need help?
General
