Omron E5EN - Page 8

Preface I.....................................
Precautions II.................................
Safety Precautions III...........................
Notice IV......................................
Conventions Used in This Manual V..............
CHAPTER 1 INTRODUCTION 1Ć1...........................
1.1 Names of Parts 1Ć2..........................................
Front panel 1Ć2.........................................................
Display 1Ć2............................................................
How to use keys 1Ć3....................................................
1.2 I/O Configuration and Main Functions 1Ć4......................
I/O configuration 1Ć4....................................................
Main functions 1Ć5......................................................
1.3 How Setup Levels Are Configured and Operating
the Keys on the Front Panel 1Ć6...............................
Selecting parameters 1Ć8................................................
Fixing settings 1Ć8......................................................
1.4 Communications Function 1Ć9................................
CHAPTER 2 PREPARATIONS 2Ć1...........................
2.1 Installation 2Ć2..............................................
Dimensions 2Ć2........................................................
Panel cutout 2Ć2........................................................
Mounting 2Ć3...........................................................
Draw out 2Ć4...........................................................
2.2 Wiring Terminals 2Ć5.........................................
Terminal arrangement 2Ć5...............................................
Precautions when wiring 2Ć5.............................................
Wiring 2Ć5.............................................................
CHAPTER 3 BASIC OPERATION 3Ć1........................
3.1 Initial Setup Examples 3Ć2....................................
3.2 Setting the Input Type 3Ć4....................................
Input type 3Ć4..........................................................
3.3 Selecting _ C/ _ F 3Ć5.........................................
Temperature unit 3Ć5....................................................
3.4 Selecting PID Control or ON/OFF Control 3Ć6...................
3.5 Setting Output Specifications 3Ć7..............................
Control period 3Ć7......................................................
Direct/reverse operation 3Ć7..............................................
3.6 Setting the SP 3Ć9...........................................
Changing the SP 3Ć9....................................................
3.7 Executing ON/OFF Control 3Ć10................................
ON/OFF Control 3Ć10....................................................
Setup 3Ć11..............................................................
Table of Contents