Omron E5EN User Manual

3.8 Determining PID Constants (AT, ST, manual setup) 3Ć12...........
AT.(autoĆtuning) 3Ć12.....................................................
ST (selfĆtuning) 3Ć13.....................................................
ST start conditions 3Ć14..................................................
ST stable range 3Ć14.....................................................
Manual setup 3Ć15.......................................................
3.9 Alarm Outputs 3Ć17...........................................
Alarm type 3Ć17.........................................................
Alarm value 3Ć18........................................................
3.10 Heater Burnout Alarm (HBA) 3Ć19..............................
HBA detection 3Ć19......................................................
Operating conditions 3Ć19.................................................
Setup 3Ć20..............................................................
How to calculate detection current values 3Ć21...............................
Example 3Ć21...........................................................
3.11 Requests during Operation 3Ć22................................
CHAPTER 4 APPLIED OPERATION 4Ć1......................
4.1 Shifting Input Values 4Ć2.....................................
Shifting input 4Ć2.......................................................
How to calculate input shift values (2Ćpoint shift) 4Ć3.........................
1Ćpoint shift method 4Ć4.................................................
2Ćpoint shift method 4Ć4.................................................
Example of 2Ćpoint temperature input shift 4Ć5..............................
4.2 Alarm Hysteresis 4Ć6........................................
Standby sequence 4Ć6..................................................
Alarm latch 4Ć6.........................................................
Close in alarm/open in alarm 4Ć7..........................................
4.3 Setting Scaling Upper and Lower Limits (analog input) 4Ć8........
Analog input 4Ć8........................................................
4.4 Executing Heating and Cooling Control 4Ć10.....................
Heating and cooling control 4Ć10...........................................
Setup 4Ć11..............................................................
4.5 To Use Event Input 4Ć12.......................................
Setting event input 4Ć12..................................................
How to use multiĆSP 4Ć12.................................................
Setting by key operation 4Ć13.............................................
Setup 4Ć13..............................................................
Executing run/stop control 4Ć14............................................
4.6 Setting the SP Upper and Lower Limit Values 4Ć15...............
Set point limitter 4Ć15....................................................
Setup 4Ć16..............................................................
4.7 Executing the SP Ramp Function
(limiting the SP change rate) 4Ć17..............................
SP ramp 4Ć17...........................................................
4.8 To Move to the Advanced Function Setting Level 4Ć19............
4.9 Using the Key Protect Level 4Ć20...............................
Key protect 4Ć20.........................................................

Omron E5EN Specifications

General

Size	48 x 96 mm
Weight	Approx. 300 g
Input Type	Thermocouple, RTD, Analog
Output Type	Relay, Voltage, Current
Power Supply Voltage	100 to 240 VAC
Display Type	Digital
Number of Control Outputs	1
Communication	RS-485
Ambient Operating Temperature	-10 to 55 °C
Ambient Operating Humidity	25 to 85% RH