VI
● Precautionary Information
CAUTION
Do not touch the terminals when power is being supplied.
For Surface-mounting H8PS, always connect the terminal cover
for after completing wiring. Otherwise, minor injury due to electric
shock may occasionally occur.
Do no allow metal fragments, lead wire scraps, or chips from pro-
cessing during installation to fall inside the H8PS. Otherwise,
minor electric shock, fire, or malfunction may occasionally occur.
Tighten terminal screws to a torque of 0.8 N·m so that they do not
become loose.
Minor fires or malfunction may occasionally occur.
For 16- and 32-output Models, leave the protective label attached
to the H8PS when wiring. Removing the label before wiring may
occasionally result in fire if foreign matter enters the Unit.
Remove the label after the completion of wiring to ensure proper
heat dissipation. Leaving the label attached may occasionally
result in fire.
Do not disassemble, modify, or repair the H8PS or touch any of
the internal parts. Otherwise, minor electric shock, fire, or mal-
function may occasionally occur.
To Next Page
Loading...
