Omron H8PS - Page 83

4.1 Mode Transitions
4-3
HOW TO USE THE
ADVANCED FUNCTIONS
Operation
mode
Display Outline Main functions
Programming
mode
[PRG] lights. In this mode, programming
and setting, e.g. writing cam
programs and setting ADV
values, are performed.
No outputs will be given in
this mode.
• Writing cam programs
(manual/teach)
• Clearing cam programs
• All clear
• Setting the origin
• Setting the ADV value
• Switching to the function
setting mode
Test mode [TST] lights. In this mode, programming
and setting, e.g. writing cam
programs and setting ADV
values, are performed while
confirming the outputs. This
mode should also be
selected for making adjust-
ments such as changing the
settings while running the
Cam Positioner.
• Writing cam programs
(manual/teach)
• Clearing cam programs
• All clear
• Setting the origin
• Setting the ADV value
Run mode [RUN] lights. In this mode, normal opera-
tion is performed.
Programming and setting
operations such as writing
cam programs and setting
ADV values are not possible.
• Checking cam programs
• Switching the display
between Speed and
Angle
• All protection
Function set-
ting mode
In this mode, the convenient
functions and advanced
functions are set.
• F1 Number of pulse out-
puts
• F2 Pulse output start
angle
• F3 Speed alarm
(upper limit)
• F4 Speed alarm
(lower limit)
• F5 Step number limit
• F6 Cam protection
• F7 Bank enable/disable
• F8 Bank switching
method
• F9 Bank copy
• F10 E24 detection
enable/disable