4-5
INITIAL SETTING
Clear All
If you are confused about how parameters have been set during initial setting, you
can clear all the parameters and start all over again.
For details on how to clear all parameters, refer to "5-17 Clearing All Parameters".
The "number of measurements
for averaging" and "hysteresis"
can be changed if required.
These parameters are to be
set at the advanced-function
setting level.
4-2 K3MA-L (Temperature meter)
F. Bring the product into measuring operation.
*For details on parameter setting, refer to "CHAPTER 5 OPERATION".
To Next Page
Loading...
Need help?
General
