5-9
OPERATION
Operation level
The forced-zero operation is
not available when the
current value is not normal
(input abnormally, outside-
the-range specified, not
measured yet).
5-6 Setting/Releasing the Forced-zero Operation (K3MA-J)
5-6 Setting/Releasing the Forced-zero
Operation
(K3MA-J)
Setting the forced-zero
The forced-zero operation allows you to shift the current value to zero forcedly.
Procedure
A. Press the U key when a current value is displayed on the main indicator.
(Release the key within one second.)
• The current value will be shifted to zero.
• "ZERO" in the operator indication section is illuminated, indicating the cur-
rent value has been shifted to zero.
Releasing the forced zero
Release the forced-zero operation.
Procedure
A. Press the U key and hold it down for at least one second when a shifted value
is displayed.
• The shifted value will be restored to the current value.
• "ZERO" in the operation indicator section will go off, indicating the current
value is no longer shifted.
To Next Page
Loading...
