56
5. Press the Shift Key to display the set value 1.0000 for changing. The PROG
indicator will flash.
Set Value LED Display Model Basic Model
6. Press the Up and Shift Keys to set the value to 0.5000. The input will be vali-
dated automatically if no change is made for five seconds. The ps.ax pres-
caling value X (mantissa) of input A setting will be displayed again.
Note Press the Mode Key to enter the set value immediately. The ps.ax
prescaling value X (mantissa) of input A setting will be displayed for
setting the next parameter.
Set Value LED Display Model Basic Model
7. Press the Mode Key to display the ps.ay prescaling value Y (exponent) of
input A setting.
Set Value LED Display Model Basic Model
8. Press the Shift Key to display the set value 10Ć1 for changing.
Set Value LED Display Model Basic Model
9. Press the Up and Shift Keys to set the value to 10 Ć1. The input will be vali-
dated automatically if no change is made for five seconds. The ps.ay pres-
caling value Y (exponent) of input A setting will be displayed again.
Note a) Press the Mode Key to enter the set value immediately. The decp
decimal point position setting will be displayed again.
b) If the set operating mode is F2 through F5, the ps.bx prescaling
value X (mantissa) of input B setting will be displayed.
Set Value LED Display Model Basic Model
Setting Mode
Section 4-2
To Next Page
Loading...
Need help?
General
