To Next Page

To Previous Page

1, 2, 3... 1. Press the Mode Key for more than one second while the setup setup menu

is displayed. The func operating mode setting will appear.

Set Value LED Display Model Basic Model

2. Repeatedly press the Mode Key until the =ro.ax auto zero time of input A X

(mantissa) setting is displayed.

Set Value LED Display Model Basic Model

3. Press the Shift Key to display the set value 9.9999 for changing. The PROG

indicator will flash.

Set Value LED Display Model Basic Model

4. Press the Up and Shift Keys to set the value to 1.0000. The input will be vali-

dated automatically if no change is made for five seconds. The =ro.ax auto

zero time of input A X (mantissa) setting will be displayed again.

Note Press the Mode Key to enter the set value immediately. The auto zero

time of input A Y (exponent) setting will be displayed for setting the

next parameter.

Set Value LED Display Model Basic Model

5. Press the Mode Key to display the =ro.ay auto zero time of input A Y (expo-

nent) setting.

Set Value LED Display Model Basic Model

6. Press the Shift Key to display the set value 10 09 for changing.

Set Value LED Display Model Basic Model

7. Press the Up and Shift Keys to set the value to 10 00. The input will be vali-

dated automatically if no change is made for five seconds. The =ro.ay auto

zero time of input A Y (exponent) setting will be displayed again.

Setting Mode

Section 4-2

Omron K3NR User Manual

Questions and Answers: