3-3 Displaying the Desired Program Section
3-3-11 Jumping from a PT User Screen to Where an Alarm Occurs
60
When the Ladder Monitor is started from the Alarm/Event Summary and
History on the sheet, the program section displayed at the bottom of the
previous screen will be displayed without searching for the address.
• The Next Button can be used to continue searching for the same
communications address.
• If the Ladder Monitor is started without the Alarm/Event Summary and
History being selected, the program section displayed at the top of the
previous screen will be displayed.
• For details on the Alarm/Event Summary and History, refer to 2-14
Alarms and Events in the NS Series PT Programming Manual (Cat. No.
V073).
• If the address that is searched for is not found, a message will be
displayed at the bottom of the screen to indicate that output XXXXX.XX
was not found and that the beginning task was displayed. In that case,
the Ladder Monitor will display the beginning step in the beginning task.
• When DM, EM, or EM0 to EM18 bits/word are searched for as alarms
with a CS1, CJ1, or CP-series CPU Unit, the address search will be
performed in words. When DM, EM, or EM0 to EM18 bits/word are
searched for as alarms with a CJ2 CPU Unit, instructions using the
address as an output will be searched for first and then the address
search will be performed in words.
To Next Page
Loading...
Need help?
General
